Is this an error showing up in ISTA? If so then try performing a repair plan to see if this controller has another way of implementing this sensor.
Pin 7 is only applicable if you want to power the ///M badges - either run a line from BDC (OEM), or use the 12V line from the underseat illumination (always on while driving).
Quote:
Originally Posted by techwhiz1
No the seat occupancy sensor replacement went great. That code cleared.
What is not working is the position sensor or how the position sensor works on the new seat. I noticed that my new seat didn't have a gray sub connector in the yellow plug. That gray connector goes to the position sensor which is some type of hall effect sensor.
The position sensor is too itor the position of the seat to decide how to deploy the airbag.
No issues moving it, but it's strange that the new seat didn't have a position sensor or that function is not somewhere in the module.
Also not really sure the pin 7 thing. I'm not sure what pin 7 on the module you are talking about.
Adding and moving wires isn't an issue. Just not sure what to do.
So if you can tell me what you are talking about pin 7 on the controller I'll wire that to pin 15 in the yellow plug.
Also any insight on the position sensor would be great.
Hate to be a bother, but I'm more than willing to pay you for your time if we can connect directly some way.
|