Quote:
Originally Posted by Technic
Is this an error showing up in ISTA? If so then try performing a repair plan to see if this controller has another way of implementing this sensor.
Pin 7 is only applicable if you want to power the ///M badges - either run a line from BDC (OEM), or use the 12V line from the underseat illumination (always on while driving).
|
Oh, yeah, I don't really care about the lights in the badges.
There is an error and I tried a repair plan but it doesn't find the position sensor. It says open circuit.
Also the lumbar and bolsters aren't working on the passenger seat but fine on the driver seat.
But I'll go ahead and move the sensor and double check all connection on the module.
Thanks again.