View Single Post
      01-02-2018, 03:27 PM   #168
tdott
Brigadier General
3931
Rep
3,972
Posts

Drives: M3
Join Date: Nov 2010
Location: South FL / 6ix

iTrader: (4)

Quote:
Originally Posted by zx10guy View Post
My NVR is connected to my PoE+ switch that is powering my IP cameras.
Did you have access each camera directly to ensure the IP Config was correct?

The NVR is a PITA, I went to do the actual install over the holidays running the cat6 and mounting the cameras outdoor and it was a pain.

I had setup one camera already and updated the NVR firmware in my office to make sure I got everything working. It wouldn't recognize the cameras after I decided to change the IP subnet, and installed both the already setup first camera and new 2nd camera. Got the 1 camera I already had setup recognized after I switched the subnet back to what it was. I still can't get a new 2nd camera setup yet. Thinking of maybe sending it back and switching to another system.

I pray for anyone who doesn't understand Tech, this shit is not user friendly even for someone who is familiar with computer networking.
Appreciate 0