View Single Post
      05-09-2019, 09:44 AM   #221
evanevery
Lieutenant Colonel
evanevery's Avatar
1111
Rep
1,904
Posts

Drives: iXM60, i8 Rdstr, M4, i7 M70
Join Date: Feb 2012
Location: Wisconsin

iTrader: (0)

Quote:
Originally Posted by fbuzila View Post
check this: https://f80.bimmerpost.com/forums/sh...=963084&page=3

http://i180.photobucket.com/albums/x...i/DSCF1107.jpg

and then look at the pdf you sent showing the Soundbooster install (page 2)

it's the same plug; in pdf picture it has a part number but I cannot find it..not yet at least
..one other thing to consider when hunting for that connector...

If you take a look at the photos in the Maxhaust install instructions you will see that there are a couple of "pin blocks" which slide out of the connector. The size, type, and layout of the pins used with that connector can change based on the specific "pin blocks" that are inserted into it.

For example, if I remember correctly, our harness uses two different size pins in a specific arrangement (audio pins/wires are larger than the CANBus pins/wires).

The point is, just because you see an angled CAMlock connector which appears to match that used by our External Amp, be wary that the actual pin arrangement/layout used inside the connector may not be identical.

Just a heads-up...
Appreciate 1
fbuzila365.50