Quote:
Originally Posted by SteveB_UK
The only hard part of the install appears to be routing the power feed loom up to front of the car.
The power need must be quite low as it's just a couple of electronics boxes - is there enough capacity in the stereo amp power feed as using that would make the install much easier!?
|
don't know, I just followed the instructions...it uses a 5+5=10amp fuse...
it's not hard at all, just unclip the door sil and the rear passanger side panel and you'll find the factory harness coming from the trunk to the front.
Just route the wire along that.