Quote:
Originally Posted by gtthree
Hi
Can anyone advise how to continue the tear down of a CIC controller?
I've managed to remove the circuit board but I cannot figure out the next step.
I'm trying to remove the ceramic control to retro fit to my CIC controller which is ten pin.
Any assistance would be greatly appreciated.
gtthree
|
Looks to me like you're at this step:
Quote:
Originally Posted by TimeFor
With the top PCB board and ribbon removed you’ll now see the rest of the black plastic knob. The center piece pops off. This can be tricky and you’ll need to pry around with the screwdriver. I found two small square ends on the center disc where I pressed in and pulled up. Eventually that center will pop up. Once the center clip is removed the whole knob lifts up. From here it should be easy to lift off the various plastic pieces, clips, buttons, and components that make up the top half of the iDrive controller.
|