[Wasa]

Am I able to use wheel as following spec :



Size: 19" x 8.5" offset 45 all around
Bolt pattern: 5 x 112
Hub Bore: 66.5


Tire size 235/35/19

[note46]

That offset is higher by 7mm vs the stock 19x8.5" i4 wheel. Also the stock tire size for that width wheel is 245/40/19. Hub bore on stock wheel is 66.6mm. Bolt pattern is fine. The wheel might fit fine on the rear but not so sure on the front.

[markw10702]

This web site might be helpful

https://www.willtheyfit.com/index.ph...0.5&offset2=22

[jpuffmasterpuffpuffpuff69]

If you have the front larger brakes, probably not. Probably fine on regular brakes, but yeah, maybe a bit tight. It can vary a lot by the specific model of wheel, depending on their design. Just make sure the company has a good return policy.

[Wasa]

Originally Posted by markw10702

This web site might be helpful

https://www.willtheyfit.com/index.ph...0.5&offset2=22

I got the calculation result as follow：

[Wasa]

Originally Posted by jpuffmasterpuffpuffpuff69

If you have the front larger brakes, probably not. Probably fine on regular brakes, but yeah, maybe a bit tight. It can vary a lot by the specific model of wheel, depending on their design. Just make sure the company has a good return policy.

I should have reg brakes as it’s 40i model