01-27-2019, 10:27 PM | #1 |
Lieutenant
174
Rep 532
Posts |
I3S - fender flares
I haven't confirmed that they come primed or unpainted (one site realoem says painted, another says primed)... but does anyone know how they attach. Fasteners? Adhesive tape (likely?)
If they just have adhesive should be an easy mod and they're not that expensive. Last edited by NashvegasR; 01-27-2019 at 10:42 PM.. |
01-28-2019, 06:25 PM | #2 |
Lieutenant
254
Rep 436
Posts |
according to realoem it's attached with screws: pn 07147304573
in realoem when you see part numbers in a circle, it means that those are the subparts needed to attach the main part. |
Appreciate
0
|
01-30-2019, 04:12 PM | #4 |
Lieutenant
254
Rep 436
Posts |
|
Appreciate
0
|
01-30-2019, 04:56 PM | #5 |
Enlisted Member
15
Rep 47
Posts |
I was thinking the same possibility. If you assume that both models start off with the same fenders, and there are no holes in the fenders in the non-S models, it would make sense that the flares attach discretely.
I hope the holes in the fender liners are the answer. |
Appreciate
0
|
01-31-2019, 09:39 AM | #6 |
Captain
111
Rep 807
Posts |
It can be done guys but a lot of your time and fabrication is needed. Not worth your while unless you are patient guys.
__________________
Garage: BMW i3 Giga World BEV | BMW E70 X5 Last edited by Vitalität; 01-31-2019 at 09:45 AM.. |
Appreciate
1
VetteZ0662.50 |
02-20-2020, 02:04 PM | #8 |
Private
7
Rep 58
Posts |
Hi, I have the pieces and the truth is that I see a lot of complication putting them. how have you done Have you lowered the pieces from behind and then hit and screwed? Or have you made holes and grooves in the car body? I appreciate your help.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|